奥斯达蓄电池6FM65西宁办事处报价

【青海】：1地级市——西宁

2县级市——格尔木、德令哈

奥斯达蓄电池充电慢是什么原因

奥斯达蓄电池使用中充不进电的原因

奥斯达蓄电池内部是否有干涸现象还应检查极板是否存在不可逆硫酸盐化。在充电时，电池的电压上升特别快，某些单格电压特别高，超出正常值很多；放电时电压下降特别快，极板的不可逆硫酸盐化，可通过充放电测量其端电压的变化来判定。电池不存电或存电很少，出现上述情况，可判断电池出现不可逆硫酸盐化。

检查充电器有无损坏，充电参数是否符合要求：奥斯达蓄电池即初期充电电流达到1.6-2.5A/只；最高充电电压达到14.8-14.9V/只，充电浮充电转换电流达0.3-0.4A/只，浮充电压达到14.0-14.4V/只。检查充电回路的连接是否可靠，检查连线与插头接触是否完好，认真检查插座和插头是否有“打火”烧弧现象，有无线路损伤断线等。

Osda battery internal drying phenomenon should also be checked whether there is irreversible sulfuric acid plate.When charging, the voltage of the battery rises very fast, some single grid voltage is very high, much higher than the normal value;Discharge voltage drop is particularly fast, the irreversible sulfuric acid of the plate, can be measured by the charge and discharge of its voltage changes to determine.Battery does not store electricity or very little electricity, the above situation, the battery can be judged to have irreversible sulfuric acid.

Check whether the charger is damaged and whether the charging parameters meet the requirements: the initial charging current of ostar battery reaches 1.6-2.5a/set;The maximum charging voltage is 14.8-14.9v/set, the conversion current of floating charging is 0.3-0.4a/set, and the floating charging voltage is 14.0-14.4v/set.Check whether the connection of the charging circuit is reliable, check whether the connection line is in good contact with the plug, carefully check whether the socket and plug have "spark" arcing phenomenon, whether there is any line damage or breakage.